Sunday, July 28, 2013

Automatic roof water tank circuits basics

The roof of the water tank through the Swiss take the basics of motor control is a problem, such as a water tank or a tank full of water into drains. Now the trouble is, now out of the water tank is on the motor and the automatic motor of flowers may be automatic. Work for the benefit of the tank and circuits are described,This is a very simple circuit. IC sarkite that the connection has been made the connection that it was just pay, all you have to parse the value sarkite. Dc 12VOLT pauyara supply circuit switch.
Please take the water tank and the tank inside a pipe plasatika abastaya stand up there, whatever the type of pipe plasatika's three losses have involved lots of travel to distant places of copper. Paipata better use of the tank stand. The copper plate was shot in the back duratte fitted sheet, just like the size of the lagabena. The fitted sheet copper pipes from three to three of its connection, it has been shown in the film. Three of the P2-P1-P3, sarkitatira with this form of the P2-P1-p3. P1-P1 connection lagabena fixations. P2 and P2 lagabena connection. Kanekasana lagabena with P3 P3.
• whenever the P1-P2-P3-fitted to the tank to keep the water level above kanekasanera dikhe ute and P2 in the ICT exceeds that of the D400 tranjatarera base in volts, and the result is a lot tranjaterera Collector fitted with matarati relay is off.• Check that the water level goes down to the level of P1 and P3 lebhalera majhamaji only tranjestara base volts D400 calo calo matarati in the water, and the relay is on the move.• sarkitatite that the relay has been shown to switch the relay with your byabahita matarera empiyarera sucati do not need to buy a relay switch that can burn.

 Photo: ছাদের ট্যাংকে অটোমেটিক পানি উঠানোর সার্কিট

ছাদে পানির ট্যাংকে পানি উঠানোর মোটর টাকে সুইসের মাধ্যমে নিয়ন্ত্রণ করতে অনেক সমস্যা হয়ে থাকে, যেমন ট্যাংকে পানি ফুরিয়ে যায় বা ট্যাংক ফুল হয়ে পানি পড়ে যায়। এখন সব ঝামেলা শেষ, এখন ট্যাংকে পানি ফুরিয়ে গেলে অটোমেটিক মোটর অন হয়ে যাবে এবং ফুল হইলে অটোমেটিক মোটর অফ হয়ে যাবে। কাজের সুবিধার জন্যে ট্যাংক এবং সার্কিটের বর্ণনা দেওয়া হল, 
এটি একটি খুব সহজ সার্কিট। সার্কিটে আইসি থেকে যে ভাবে কানেকশন গুলো দেয়া হয়েছে ঠিক সে ভাবে কানেকশন গুলো দিবেন, সব পার্সের মান সার্কিটে দেওয়া আছে। সার্কিটটি Dc 12VOLT পাউয়ার সাপ্লাই এ চলে।

পানির ট্যাংক টাকে ভাল করে লক্ষ করুন ট্যাংক এর ভিতরে একটি প্লাশটিক পাইপ নিচ থেকে উপরের দিকে দাঁড়ানো অবস্তায় আছে, যাই হোক এবার লক্ষ করুন প্লাশটিক এর পাইপ টিতে তিনটি যায়গায় তামার পাত জড়ানো আছে। ট্যাংকে দাঁড়ানো পাইপটা ভাল করে লক্ষ করুন। তামার পাত গুলি যত টুকু দুরত্তে লাগানো হয়েছে ঠিক সেই মাপ মত পাত গুলি লাগাবেন। পাইপ এ লাগানো তিনটি তামার পাত থেকে তিনটি তার কানেকশান করতে হবে, ঠিক যেভাবে ছবিতে দেখানো হয়েছে। তিনটি তার হল P2-P1-P3 , সর্কিটটির সাথেও এই রুপ P2-P1-p3 রয়েছে। P1-এরসাথে P1 কানেকশন লাগাবেন। P2 সাথে P2 কানেকশন লাগাবেন। P3 সাথে P3 কনেকশন লাগাবেন। 

• যখনি P1- P2- P3- লাগানো কানেকশানের ট্যাংকে রাখা পানির স্তরটি উপরের দিখে উটে এবং P2 কে অতিক্রম করে তখনই আইসিটি থেকে D400 ট্রান্জটরের বেইজ ভোল্ট কে অফ করে দেয় , ফলে ট্রান্জটেরের কালেক্টরে লাগানো রিলেটি বন্দ হয়ে যায় এবং সাথে সাথে মটরটি অফ হয়ে যায়।
• টিক তেমনি ভাবে পানি স্তর যখন নিচে চলে যায় P1 এবং P3 লেভলের মাঝামাজি লেভেলে থাকে তখনি D400 ট্রান্জেষ্টর বেইজ ভোল্ট চালো হয় এবং রিলেটি অন হয় ফলে মটরটি চালো হয়ে পানি উঠানো শুরু করে।
• সার্কিটটিতে যে রিলে সুইচটি দেখানো হয়েছে আপনার ব্যবহিত মটরের এম্পিয়ারের সাথে মিলিয়ে রিলে সুচটি কিনতে হবে না হয়ত রিলে সুইচটি পুড়ে নষ্ট হয়ে যেতে পারে।
(কোন কিছু জানার থাকলে কমান্ড করতে ভুলবেন না, 
এই রকম সার্কিট পাইতে লাইক এবং কমান্ড করে পেজের সাথে থাকুন)

No comments:

Post a Comment

 

Blogger news

Blogroll

About